User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
155
c [Input] indicator
Displays the status of the signals input to each input port. The indicator turns off when "0"
is input, and turns on when "1" is input.
d [Port] list box
Selects the target for editing.
e [Comment] text box
Allows for input of text. For example, it can be used to enter a description of an event to
make it easier to identify.
f [Command] button
When 0 is selected, the command that will be sent when 0 is input to the input port will be
edited in the [Hex] text box.
When 1 is selected, the command that will be sent when 1 is input to the input port will be
edited in the [Hex] text box.
g [Hex] text box
The command can be entered in hexadecimal.
h [Override] button
When this has been set to on, the [Hex] text box is overwritten. Turn off to insert.
i [Test] button
The command entered in the [Hex] text box is sent directly from ProVisionaire Design.
j [Hex] Clear button
Deletes the contents of the [Hex] text box.
k [Convert] button
Converts the text string command entered in the [Ascii] text box into hexadecimal, and
reflects it in the [Hex] text box.
l [Ascii] text box
The command can be entered as a text string.
m [Ascii] Clear button
Deletes the contents of the [Ascii] text box.