User Manual
Table Of Contents
- Introduction
- Audio Components
- The Difference Between Mono, Stereo, and Multi
- How to Control Control Signals
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Control (AGC)
- Combiner
- Room Combiner/Room Combiner plus Automixer
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- ■ “Room Combiner” component editor/”Room Combiner plus Automixer” component editor
- Combiner parameter setting window (Room Combiner)
- Combiner parameter setting window (Room Combiner plus Automixer)
- Control
- Control
- Dugan Automixer window (Room Combiner plus Automixer)
- Room Combiner/Room Combiner plus Automixer
- DCA
- Delay
- Dynamics
- REV-X
- EQ
- Fader
- Feedback Suppressor
- Filter
- Input/Output
- Meter
- Mixer
- Oscillator
- Polarity
- Probe
- Router
- Source Selector
- Speaker Processor
- Control Components
- Control Methods for Control Components
- Trigger
- Button (Normalized Value)
- Button (Value)
- Radio Button (Normalized Value)
- Radio Button (Value)
- Fader (Normalized Value)
- Fader (Value)
- Processing
- Logic (Normalized Value)
- NOT (Normalized Value)
- Flip-Flop (Normalized Value)
- Invert (Normalized Value)
- Compare (Normalized Value)
- Difference (Normalized Value)
- Max/Min (Normalized Value)
- Negate (Value)
- Compare (Value)
- Multi Compare (Value)
- Difference (Value)
- Max/Min (Value)
- Delay
- External Events
- Suspend
- Router
- Other
- GPI In
- GPI Out
ProVisionaire Design DME7 Component Guide
101
Probe
Probes have 2 functions. The first is to monitor any output point. Using two probes, each
signal can be independently and simultaneously monitored, and the relationship between the
two signals can also be checked. When output to Dante, you can listen to audio on a
computer using the Dante Virtual Soundcard. In addition, 2 outputs can be input to Smmart
to see the correlation. The other function of a probe is to temporarily interrupt the oscillator
signal to a specific input point. For details about the oscillator, refer to Oscillator component
editor.
Each DME7 sets whether the probe is ON or OFF.
Audio
Only one component can be placed.
■ ”Probe” component editor
a
Probe [ON] button
Turns the probe monitor function ON or OFF. The cursor changes to the probe shape.
b OUTPUT meter
Displays the output signal level of Oscillator.
c OUTPUT [LEVEL] knob
Specifies the output level of Oscillator.