Operation Manual

Anti-tumble measures

Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury.

Securing to a wall or pillar

Use a commercially available cord, chain and clamp, secure the set to a firm wall or pillar.

Securing desktop

1) Using wood screws (two), fasten the set to the clamping screw holes on the rear of the

stand as shown.

2) Using commercially available wood screws, secure the set firmly in position.

INSTALLATION INSTRUCTIONS

Installation

• In order to prevent an internal temperature increase, maintain a space of 10cm (4 inches :

For a desktop set-up) or more between the sides and other objects such as walls, etc.,

so that the ventilation holes are not blocked.(*)

10cm (4 inches) or more

Cord

chain

Clamp

Hook

Chain

cord or chain

clamp

Wall or Pillar

Two places

Wood screw

Use one of the special mount units to install this product. A mount of insufficient strength or inadequate design can cause overturning or

dropping and result in fire, electrical shock or injury. Please note that our company assumes absolutely no responsibility for personal

injuries or property damage caused by use of other mount units or improper installation.

WARNING

CAUTION

Read CAUTION ( to ) carefully to ensure maximum safety before proceeding to these

steps:

• Choose an appropriate site and install the product on a level table where the stand is secure.

• Install the monitor to have ready access to a power socket available.

• Make sure that the power switch of this device is turned off.

012_PDM-4420_G_E 6/15/05, 9:26 PM12