Owner`s manual

12
Tachometer unit
01 (resetting maintenance intervals)
You can reset the elapsed time from the
previous maintenance interval (when the
meter was reset).
1. Turn the engine off and the engine start
switch to ON.
2. (4 seconds): To activate the cus-
tom mode and to switch to the resetting
display.
3. + (1 second): To reset the
elapsed time to “0h” and return to the
normal display.
NOTE:
Press the button for 1 second from
step 2 to cancel the resetting of the elapsed
time and return to the normal display.
02 (setting trim angle)
You can set the trim angle to zero.
Fully trim the outboard motor down.
1. Turn the engine off and the engine start
switch to ON.
2. (4 seconds): To activate the cus-
tom mode.
3. (1 second): To switch between
the setting function numbers and to
switch to the zero adjustment display.
4. + (1 second): To adjust the
trim angle to zero using the current trim
position as the standard value and
return to the normal display.
NOTE:
• When one segment is displayed, the trim
angle of the outboard motor is adjusted to
zero (full trim in).
• Press the button for 1 second from
step 3 to cancel the adjustment of the trim
angle to zero and return to the normal dis-
play.
Blinks
01 (resetting maintenance intervals)/02 (setting trim angle)