User Manual

6EN
q Slide the tab on the endpin section in the direction indicated by the
arrow in the diagram below to release the lock, then pull out the battery
holder.
w Insert two AA batteries making sure that the battery poles are properly
aligned with the polarity markings on the battery holder.
e Slide the battery holder back into the endpin section until it locks.
NOTICE
When using nickel metal-hydride batteries, take care not to damage the
battery casing or poles when installing and removing the batteries.
Remaining Battery Level
The LED located inside the Master Volume flashes red when it is time to
change the batteries. Once the LED begins flashing, the remaining opera-
tion time is approximately two hours with alkaline batteries and about one
hour when using nickel metal hydride batteries (Time varies according to
operating conditions). Please replace the batteries as soon as possible.
Replacing the Batteries
Battery Holder
AA battery
x2
Tab
Release the lock
Endpin section
system74n_en.fm Page 6 Thursday, May 23, 2019 11:19 AM