User Manual
Table Of Contents
- 数据版权相关注意事项
- 本使用说明书内容相关的注意事项
- 目录
- 第1章MTX-MRX Editor概述
- 第2章菜单栏和工具按钮
- 第3章Project画面
- 第4章系统画面
- 第5章联机和同步
- 第6章预设设定
- 第7章对话框/软件应用程序
- “Startup” 对话框
- “Network Setup”对话框
- “Device Information”对话框
- “Match Devices by IP Address”对话框
- “MTX Configuration”对话框
- “Dante Information”对话框
- “Word Clock”对话框
- “Clock”对话框
- “Daylight Saving Time”对话框
- “Scheduler”对话框
- “Remote Control”对话框
- “External Events”对话框
- “Digital Control Panel”对话框
- “Wireless DCP”对话框
- “MCP1”对话框
- “PIN Setup”对话框
- “Label”对话框
- “Re-size Image”对话框
- “PGM1/PGX1”对话框
- “PGM1 Label Creator”应用程序
- “GPI”对话框
- “GPI Calibration”对话框
- “Security Settings”对话框
- “Project Information”对话框
- “Configuration Diagram”对话框
- “Get Log”对话框
- “Sampling Rate Converter”对话框
- “Input Source/Redundant”对话框
- 附录
“Word Clock”对话框 第 7 章对话框 / 软件应用程序
MTX-MRX Editor 用户指南
178
❑“Word Clock”对话框
此处可编辑MTX/MRX系统的字时钟设定。通常当您使用“设备配置向导”对话框创建配置
时,这些设定将被设定为最优值。如果想要将 Mini-YGDAI 卡指定为字时钟主机等时,请在
此对话框中进行设定。
●[Preserve the Dante settings configured by Dante Controller] 复选框
如果正在使用 Audinate Corporation 的 Dante 控制器设置 Dante 网络,请选择此
复选框。Dante 控制器的设定将优先于 MTX-MRX Editor 中的设定。如果清除了
此复选框,将可使用 MTX-MRX Editor 进行项目内的 Dante 网络设定。
● [Auto] 按钮
设定项目中所有 MTX/MRX 系统的字时钟和主控时钟。仅当脱机时可用。
● 系统选择选项卡
这些选项卡可选择您想要设定字时钟的 MTX/MRX 系统。
● [System Word Clock Fs:] 框
此处指定 MTX/MRX 系统的字时钟。
● [Advanced Setting] 按钮
此按钮可切换到进行高级设定的画面。上图显示单击 [Advanced Setting] 按钮时
的状态。