User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
30
Grid (Distributed Speaker Layout Pattern)
You can place speakers at intervals on your choosing on a plane. This function is useful when evaluating the sound
pressure distribution resulting from a particular placement.
Layout Judgment
Select a “Pattern” from the list box, and enter a “Pitch” (the interval between speakers).
Pattern:
Select either “Rectangular” or “Hexagonal” as a layout pattern for speakers on a plane.
Pitch:
Set the intervals at which you want to place speakers. Enter a value greater than 0 m.
Speaker Arrangement
Angle (Relative):
Set the angle of the speaker when seen from the plane. Default settings are Pan (0.0), Tilt (90.0), and Rot (0.0). The
available range is -180.0 to 180.0.
Offset from plane:
Set the offset of the speaker from the wall. The default setting is (0.00), indicating that the speaker’s rear is flat against
the plane. The available range is -90.00 m to 90.00 m (-295.0 ft to 295.0 ft).