User Manual

M7CL V3 Editor Owner’s Manual

If a MATRIX channel is selected

❏ CHANNEL SELECT (Channel selection)

Except for the fact that your editing applies to a MATRIX channel, this is the same as the channel selection for a

MIX channel (➥ p.40).

❏ FROM MIX, ST/MONO

A FROM MIX, ST/MONO send level

These adjust the send levels of the signals sent from the VARI type MIX buses or STEREO/MONO buses to the

MATRIX bus. The current value is shown in the numerical box immediately below.

B PRE(PRE/POST)

These select either PRE or POST as the position from which the signal is sent from the MIX buses or STEREO/

MONO buses to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is selected if this is off.