User Manual

M7CL V3 Editor Owner’s Manual

If a MIX channel is selected

❏ CHANNEL SELECT (Channel selection)

A SELECT (Channel selection)

Except for the fact that your editing applies to a MIX channel, this is

the same as the channel selection for an input channel (➥ p.30).

B LIBRARY

Accesses the Output Channel Library. Click this button to open the

OUTPUT CH page of the Library window.

C INPUT PATCH

Selects the input source assigned to the input channel (for the

selectable input sources, ➥ p.22)

If multiple patches have been made, only the ﬁrst port is shown.

If you change the patching in this window, the port that had been

assigned until then will be cancelled, and only the newly selected

port will be assigned.

❏ TO MATRIX

A MATRIX send level

This adjusts the send level of the signal sent from the MIX channel to the MATRIX buses.

B PRE (PRE/POST)

Select either PRE or POST as the position from which the signal is sent from the MIX

channel to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is

selected if this is off. The PRE POINT setting can be made in the Mixer Setup dialogbox.

Right-click the PRE button to display a context-sensitive menu that will enable you

to specify ALL PRE, ALL POST, or other options.

• If you are using MATRIX buses in stereo, the knob for

the odd-numbered bus will be PAN.

• The stereo/mono status can be speciﬁed in the Mixer

Setup dialogbox.

NOTE

HINT

Knob of odd-

numbered side