User Manual

Table Of Contents

Step 5 Making Audio Patches

I/O Patch View

In I/O Patch view, creating a patch requires two operations. First you must patch a transmitting

device output to an EtherSound network channel, then patch the EtherSound network channel to a

receiving device input. I/O Patch View requires more operations than Net Patch View, but allows you

to specify the EtherSound network channel assigned to each patch. This is useful in cases where the

same EtherSound network channels must carry different data on different segments of the network.

See the side notes on “Overwriting Channels.”

A device’s outputs and inputs are represented by rows, and EtherSound network channels are

represented by columns. To make audio patches, perform the following procedure:

① In the lower box of I/O patch view of the transmitting device, click on the intersection of the

transmitting device’s output and the desired EtherSound network channel.

② In the upper box of I/O patch view of the receiving device, click on the intersection of the

EtherSound network channel of the above step, and the receiving device’s input.

Left clicking allocates a downstream channel ▼ and right clicking allocates an upstream channel ▲.

Device Outputs

Device Inputs

EtherSound network channels