User Manual

Table Of Contents

Step 4 Wordclock Settings

In daisy chain EtherSound networks the device furthest upstream is the Primary Master device, and

is always the wordclock master for the EtherSound network. Thus the wordclock master for the

network does not need to be specified by the user. The wordclock settings for each device will depend

on if the device is Primary Master or Non-Primary Master.

Notes: In Fault Tolerant Ring topologies since there is no “first” device, the wordclock master must be

specified by the user. Refer to Step 7) Making the System Redundant.

Wordclock Source and Sampling Frequency

Wordclock source and Sampling frequency settings differ depending on the device.

■MY16-ES64 (M7CL) settings

Wordclock Source

The wordclock source setting depends on if the device is Primary Master or Non-Primary

Master.

Primary Master

Select “INT”(internal) or any non-EtherSound network wordclock source.

Non Primary Master

Select “SLOT”, (the slot containing the MY16-ES64 card) as the wordclock source.

In this example, since the MY16-ES64 (M7CL) is the Primary Master, it must supply

wordclock to the network. For our example, set the M7CL’s wordclock source to “INT

48kHz”.