User Manual

Top panel
Panels and controls
17
M7CL Owner’s Manual
2
If an optional MBM7CL meter bridge is installed, the
MIX/MATRIX channel levels can be monitored at all
times. The monitoring position can be selected from PRE
EQ (immediately before attenuator), PRE FADER (imme-
diately before the fader), or POST ON (immediately after
the [ON] key).
1 MIX meters
These indicate the level of MIX channels 1–16.
B MATRIX meters
These indicate the level of MATRIX channels 1–8.
In this section you can control the mix parameters for the
currently selected input channel or output channel.
1 [MIX/MATRIX] encoders
● When an input channel is selected
This adjusts the send level of the signal sent from that
channel to the MIX/MATRIX buses.
● When a MIX channel is selected
This adjusts the send level of the signal sent from the
selected MIX channel to the MATRIX buses.
● When a MATRIX channel is selected
This adjusts the send level of the signal sent from each
MIX channel to the selected MATRIX bus.
B [HA] encoder
Adjusts the head amp gain of an input channel. This does
nothing if another type of channel is selected.
C [PAN] encoder
● When an input channel is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels (or L/C/R
channels) of the STEREO bus.
● When a ST IN channel is selected
This adjusts the left/right balance of the signals that
are sent from the selected two channels to the STE-
REO bus.
● When a MIX channel (MONO x 2) is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels of the STE-
REO bus.
● When a MIX channel (STEREO) is selected
This adjusts the left/right balance of the signals that
are sent from the selected two channels to the STE-
REO bus.
● When a MATRIX channel (STEREO) is selected
This adjusts the left/right balance of the signals that
are sent from the selected two channels to the STE-
REO bus.
● When a STEREO channel is selected
This adjusts the left/right balance of the signals that
are output from the L/R channels of the STEREO bus.
D [DYNAMICS 1] encoder
● When an input channel is selected
Adjusts the THRESHOLD parameter of the gate, etc.
● When a MIX, MATRIX, or STEREO/MONO
channel is selected
Adjusts the THRESHOLD parameter of the compres-
sor, etc.
E [DYNAMICS 2] encoder
● When an input channel is selected
Adjusts the THRESHOLD parameter of the compres-
sor, etc.
● When a MIX, MATRIX, or STEREO/MONO
channel is selected
No function.
F [HPF] encoder
Adjusts the HPF cutoff frequency for an input channel.
This does nothing for other types of channel.
G EQ [Q], EQ [FREQUENCY], EQ [GAIN] encoders
For each band of the four-band EQ, these adjust the Q,
center frequency (cutoff frequency), and gain.
■ Meter bridge (option)
1 2
■ SELECTED CHANNEL section
4
5
6
7
1 2 3
• The PAD will be internally switched on or off when the HA gain is
adjusted between -14 dB and -13 dB. Keep in mind that noise may
be generated if there is a difference between the Hot and Cold
output impedance of the external device connected to the INPUT
connector when using phantom power.
NOTE