Owner`s manual

Basic components
21
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
●
Memorize the trim angles that work best
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
● If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
●
Changing the display format
● Pressing the “” (mode) button chang-
es the display format in the following pat-
tern:
● Total hours → Trip hours → Display off
●
Resetting the trip hours
●
Simultaneously pressing the “” (set)
and “” (mode) buttons for more than
1 second while the trip hours are displayed
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690
Trip meter
This gauge displays the distance the boat
has traveled since the gauge was last reset.
Press the “” (mode) button repeatedly
until the indicator on the face of the gauge
points to “” (trip). To reset the trip meter
to zero, press the “” (set) and “”
(mode) buttons at the same time.
NOTE:
● The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.
● The trip distance is kept in memory by bat-
tery power. The stored data will be lost if
the battery is disconnected.
3. Selector switch (for fuel sensor)
ZMU01869
ZMU01870