Owner`s manual

Trouble Recovery
79
5. Drain the water in the filter cup by soak-
ing it up with a rag.
NOTE:
Properly dispose of the rag.
6. Firmly screw the filter cup onto the filter
housing.
NOTE:
Be careful not to twist the water detection
switch lead when screwing the filter cup onto
the filter housing.
7. Connect the water detection switch cou-
pler securely until a click is heard.
8. Install the top cowling.
9. Start the engine and make sure that the
water separator warning indicator re-
mains off.
NOTE:
Have a Yamaha dealer inspect the outboard
motor after returning to port.
EMU29541
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started manually with
an emergency starter rope. However, the en-
gine cannot be started manually if the battery
voltage is low. If the battery is discharged to
9 volts or below, the electric fuel pump will
not operate.
WARNING
EWM01021
●
Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
●
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
● Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg while operating the
boat.
●
Do not attach the lanyard to clothing
that could tear loose. Do not route the
cord where it could become entangled,
preventing it from functioning.
●
Avoid accidentally pulling the lanyard
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
1. Filter cup
2. Water detection switch lead
1. Water detection switch coupler
1
2
ZMU05501
1
ZMU05500