Owner`s manual

Trouble Recovery
77
EMU29492
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse box and use a fuse
puller to replace the fuse with a spare one of
the proper amperage.
WARNING
EWM00630
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
CAUTION:
ECM01382
●
If a main fuse has blown, be sure to also
check the other main fuse.
● If the outboard motor is operated after a
main fuse has blown charging capabili-
ty will be insufficient, and the engine
will not start.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1. Electrical cover
2. Fuse holder
3. Fuse (20 A × 3, 30 A, 80 A × 2)
4. Spare fuse (20 A, 30 A, 80 A)
5. Fuse puller
1. Fuse puller
4
5
2
3
4
3
1
ZMU04009
1
ZMU03562