Motorcycle User Manual
Table Of Contents
- Introduction
- Table of Contents
- Safety Information
- Description
- Instrument and Control Functions
- Pre-Operation Checks
- Periodic Maintenance and Minor Repair
- Owner's tool kit
- Periodic maintenance chart for the emission control system
- General maintenance and lubrication chart
- Checking the spark plugs
- To change the engine oil
- Coolant
- Adjusting the throttle cable free play
- Tires
- Clutch lever free play
- Checking the front and rear brake pads
- Checking the brake and clutch fluid levels
- Checking and lubricating the cables
- Checking the steering
- Battery
- Replacing fuses
- Replacing a headlight bulb
- Troubleshooting
- Motorcycle Care and Storage
- Specifications
- Consumer Information
- Index

PERIODIC MAINTENANCE AND MINOR REPAIR
6-24
6
indicator groove has almost disap-
peared, have a Yamaha dealer replace
the brake pads as a set.
EAU22500
Rear brake pads
Check each rear brake pad for damage
and measure the lining thickness. If a
brake pad is damaged or if the lining
thickness is less than 0.8 mm (0.03 in),
have a Yamaha dealer replace the
brake pads as a set.
EAU22680
Checking the brake and clutch
fluid levels
Front brake
Rear brake
Clutch
Insufficient brake fluid may allow air to
enter the brake or clutch systems, pos-
sibly causing them to become ineffec-
tive.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake fluid
level may indicate worn brake pads
and/or brake system leakage. If the
brake level is low, be sure to check the
brake pads for wear and the brake sys-
tem for leakage.
NOTE:
The rear brake fluid reservoir is located
behind panel F. (See page 6-8.)
Observe these precautions:
1. Lining thickness
1. Minimum level mark
1. Minimum level mark
1. Minimum level mark
U5JW12E0.book Page 24 Wednesday, April 28, 2004 10:24 AM