Specifications

Mixing Console
Reference
138
TYROS Owner’s Manual
136
■ Selecting an Effect type and creating a User Effect
Various types of Effects are provided for each Effect Block listed on page 137. Each Effect type can be
edited with the parameters (see the Effect Type Edit display below) and saved as a User Effect Type.
Select an Effect Block and a part to
which the corresponding effect is
applied. Please note that a part cannot
be selected if the selected block is used
as a System Effect. See the Effect
Block list on page 136.
● Effect Type Selection display for each block
Select an Effect type after
selecting a category.
● User Effect Type Save● Effect Type Edit
Set the value of the param-
eter selected at left.
Changes the name of the
Effect type selected at left.
Pressing the [SAVE] LCD
button calls up the pop-up
window for entering the
name of the edited Effect
type. Enter the desired
name and press the [OK]
LCD button to save the
edited effect to the location
specified at left.
Select an Effect category/type to
be edited.
Select a parameter to be edited. Parameters
displayed differ depending on the selected
Effect type. Refer to the separate Data List
booklet for details.
When the edited effect block is
a System Effect, the Effect
Return Level parameter (page
137) can be adjusted here.
Select a block to
which the desired
effect type
belongs.
Select the destination to which the
effect is to be stored.
The number of memory spaces
available for the destination differs
for each block (page 136).
• Keep in mind that in some cases noise may result if you adjust
the effect parameters while playing the instrument.
The value of the parameters when turning the [VARIATION] on
can be set as for the DSP2 - 5 blocks.
Use these LCD buttons to switch between the upper/lower
parameters. For the lower parameter, the depth can be changed
when the [VARIATION] button is on.