User Manual

204

ELB-02 Owner’s Manual

Appendix

6-2 Use the four screws (A) to fasten the Main unit to

the Sideboards as shown in the illustration.

7 Fit the Grill Net onto the Speaker.

First, align the net with the bottom line, then

secure it to the speaker assembly.

8 Plug the power cord into the AC IN jack on

the bottom surface of the main Unit.

9 Connect the Pedalboard cord and Speaker

cord to the Main Unit.

Remove the protective film applied to each

connector of the cords. Make sure that the latches

on each connector of the cords face toward you,

and connect them to each socket securely until

the latch is set. Once connected securely, the

connector cannot be accidentally disconnected,

even if you pull the connector gently downward. (If

disconnected, the pedals will not function

properly.)

Affix the two cord holders to the inside of

the side board, then insert the Pedalboard

cord in the holders as shown in the

illustration.

Fasten the Grill Net

by inserting the

knobs into the holes.

Speaker cord

Pedalboard cord

To disconnect the

Pedalboard cord and

Speaker cord:

Press the bottom of the latch

to unlatch, then disconnect.

Clamp the holder shut after

inserting the cord.