Owner`s manual

– 13 –

AE01180

APPLICATION RANGE

When using the generator, make sure the total load is within rated output of a generator.

Otherwise, generator damage may occur.

9 Do not overload. The total load of all electrical appliances must not exceed the

supply range of the generator. Overloading will damage the generator.

9 When supplying precision equipment, electronic controllers, PCs, electronic

computers, microcomputer-based equipment or battery chargers, keep the

generator a sufficient distance away to prevent electrical interference from the

engine. Also ensure that electrical noise from the engine does not interfere

with any other electrical devices located near the generator.

9 If the generator is to supply medical equipment, advice should first be obtained

from the manufacturer, a medical professional or hospital.

9 Some electrical appliances or general-purpose electric motors have high start-

ing currents, and cannot therefore be used, even if they lie within the supply

ranges given in the above table. Consult the equipment manufacturer for fur-

ther advice.

NOTICE

TIP

9 “–” means below.

9 Application wattage indicates when each device is

used by itself.

9 The simultaneous usage of AC and DC power is

possible but total wattage should not exceed the

rated output.

EX:

9 The overload indicator light 1 comes on when

total wattage exceeds the application range. (See

page 15 for more details.)

Power factor 1 0.8–0.95

0.4–0.75

(Efficiency 0.85)

EF2400iSHC –2,000W –1,600W –680W

Rated voltage

12V

Rated current

Generator rated output 2,000VA

Frequency Power factor

1.0 –1,900W

0.8 –1,500W

96W

DC —

(12V/8A)

7CF-9-16-a 11.3.21 11:38 Page 13