User Manual

Reference
36
UTILITY DANTE SETUP MODE (DANTE MODE) STANDARD STANDARD, Quick Config 23
*PATCH
<If the MODE is set to Quick Config>
NO ASSIGN
See the “Patch Correspondence Chart
when Using Quick Config” (page39)
24
UNIT ID 01 01 to FE 
11, 24
LABEL —
12 characters
(alphanumeric characters, -)

Fs (DANTE Fs) 48kHz 44.1kHz, 48kHz, 88.2kHz, 96kHz 
24
LATENCY (DANTE LATENCY) 1ms 1ms, 2ms, 5ms 
LOCK <For display only> UNLOCKED UNLOCKED, LOCKED 
25
DDM — — — — — —
STATE <For display only>
DISCONNECTED
DOMAIN, DISCONNECTED,
UNMANAGED

LOCAL <For display only> READ ONLY READ WRITE, READ ONLY 
NETWORK UNIT ID 01 01 to FE 11, 25
IP SET. (IP SETTING) DHCP UNIT ID, DHCP, STATIC IP 
25
IP ADR. — IPv4 
NETMASK — IPv4 
GATEWAY — IPv4 
MAC <For display only> — — 
DEVICE INFORMATION THERMAL <For display only> — — 
26
VERSION — — ————
FIRMWARE <For display only> — — 
Dante <For display only> — — 
SERIAL <For display only> — — 
INITIALIZE — — — 26
LOG LOG LIST — — 
27
SAVE TO USB — — 
UPDATE FIRMWARE — — — 27
DEVICE SETUP
<V1.3.0 or later, hardware ver-
sion A only>
DELAY ALIGNMENT OFF OFF, ON 28
PRESET 0: INITIAL DATA
A to C(*): Factory presets
1 to 8: User presets
* Number values may change
depending on the model in
use.
RECALL — — 
14
STORE — — 
CLEAR — — 
TITLE — — 
PROTECT — — 15
Function Category Parameter Default value Setting range
Full range Subwoofer
Page
number
Standard Dante Standard Dante