Brochure

DSR115 DSR215 DSR118W DXR8 DXR10 DXR12 DXR15 DBR10 DBR12 DBR15
General
System Type
Frequency Range (-10dB)
Coverage Angle
Crossover Type
Crossover Frequency
Measured Maximum SPL (peak)
IEC noise@1m
Transducer
LF
HF
Enclosure
Material, Finish, Color
Floor Monitor Angle
Dimensions
(W × H × D, with rubber feet)
Net Weight
Handles
Pole Socket
Rigging Points
Optional Speaker Bracket
Amplifier
Amplifier Type
Power Rating*1
Cooling
HPF/LPF
DSP preset
Protection
Connectors
Input Impedance
Input Sensitivity
(LEVEL: Maximum)
Input Sensitivity
(LEVEL: Center)
Maximum Input Level
Controls
Idle Power Consumption
1/8 Power Consumption
Power Requirements
2-way, Bi-amp powered speaker, Bass-reflex type
55Hz - 20kHz
H90° x V60° constant directivity horn
FIR-X tuning™ (Linear phase FIR filter)
1.7kHz
134dB SPL
12" cone
3"
Neodymium
2"
1" throat compression driver
Neodymium
Wood, LINE-X®, Black
50°
370 x 638 x 368mm
(14.6" x 25.1" x 14.5")
21.2kg (47lbs)
Top x 1
35mm (Bottom x 1)
Top × 2, Rear × 1
(Fits for M10 × 18mm eyebolts)
–
Class-D
1500W (LF: 1020W, HF: 480W)
1300W (LF: 850W, HF: 450W)
Natural convection
OFF, 120Hz 24dB/oct HPF
D-CONTOUR (Dynamic CONTOUR)
Clip limiting, Integral Power Protection, DC-fault
Thermal, Output over current
Thermal, Output over voltage, Output over current
XLR-3-31 x 1
TRS Phone Jack x 1
XLR-3-32 x 1
Parallel with INPUT
INPUT1: LINE: 12kΩ, MIC: 8kΩ
INPUT1: LINE: 0 dBu, MIC: -25 dBu
INPUT1: LINE: +7 dBu, MIC: -18 dBu
INPUT1: LINE: +24 dBu, MIC: -11 dBu
LEVEL, LINE/MIC, HPF, D-CONTOUR, FRONT LED DISABLE, POWER
30W
100W
North America: 120V, 60Hz, Japan: 100V, 50Hz/60Hz, Other areas: 220 - 240V, 50Hz
45Hz - 20kHz
136dB SPL
15" cone
–
442 x 755 x 423mm
(17.4" × 29.7" x 16.7")
28.0kg (62lbs)
Side x 2
45Hz - 20kHz
138dB SPL
2 x 15" cone
2.5"
Ferrite
–
467 x 1158 x 520mm
(18.4" x 45.6" x 20.5")
49.8kg (110lbs)
–
–
140W
Powered subwoofer, Bass-reflex type
40Hz - 130Hz
–
–
–
132dB SPL
18" cone
3"
Ferrite
–
–
–
–
520 x 638 x 584 mm
(20.5" x 25.1" x 23.0")
42.0kg (93lbs)
35mm (Top x 1)
–
1020W
800W
120Hz 24dB/oct LPF
–
XLR-3-31 x 2
XLR-3-32 x 2
Parallel with INPUT
INPUT1: 10kΩ
INPUT1: 0 dBu
–
–
–
INPUT1: +24 dBu
LEVEL, POLARITY,
FRONT LED DISABLE, POWER
100W
Diameter
Voice Coil
Magnet
Diaphragm
Type
Magnet
Dynamic
Continuous
Speaker
Amplifier
Power Supply
Input
Output
2-way, Bi-amp powered speaker, Bass-reflex type
57Hz – 20kHz
H90° × V60° constant directivity horn
FIR-X tuning™ (Linear phase FIR filter)
2.4kHz
129dB SPL
8" cone
2"
Ferrite
1.4"
1" throat compression driver
Ferrite
ABS, Matte black
–
280 × 458 × 280 mm
(11.0" x 18.0" x 11.0")
13.5kg (29.8lbs)
Top x 1
35mm with 2-way feature (0 or 7 degrees)
Top × 2, Rear × 1
(Fits for M8 × 15mm eyebolts)
UB-DXR8
Class-D
1100W (LF: 950W, HF: 150W)
700W (LF: 600W, HF: 100W)
Fan cooling, 4 speeds
OFF, 100, 120Hz 24dB/oct HPF
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Clip limiting, Integral Power Protection, DC-fault
Thermal, Output over current
Thermal, Output over voltage, Output over current
INPUT1: XLR3-31 × 1, INPUT2: Phone × 2,
INPUT3: RCA PIN × 2
THRU: XLR3-32 × 1 (Parallel with INPUT1),
LINK OUT: XLR3-32 × 1
INPUT1: LINE: 12kΩ, MIC: 8kΩ
INPUT2, 3: L, R: 40kΩ, MONO: 20kΩ
INPUT1: LINE: +1 dBu, MIC: -32 dBu
INPUT2, 3: -13 dBu
INPUT1: LINE: +11 dBu, MIC: -22 dBu
INPUT2, 3: -3 dBu
INPUT1: LINE: +24dBu, MIC: +20dBu
INPUT2, 3: +16 dBu
LEVEL × 3, LINE/MIC, HPF, D-CONTOUR, FRONT
LED DISABLE, LINK MODE, POWER
35W
90W
100V – 240V, 50Hz/60Hz
2-way, Bi-amp powered speaker, Bass-reflex type
55Hz – 20kHz
H90° × V60° constant directivity horn
FIR-X tuning™ (Linear phase FIR filter)
2.1kHz
129dB SPL
10" cone
2"
Ferrite
1"
1" throat compression driver
Ferrite
Plastic, Black
50°
308 x 493 x 289 mm
(12.1" x 19.4" x 11.4")
10.5 kg (23.2 lbs)
Top x 1
35mm (Bottom x 1)
Bottom x 2
(Fit for M8 x 15 mm eyebolts)
BBS251, BCS251, BWS251-300, BWS251-400
Class-D
700 W (LF: 500 W, HF: 200 W)
325 W (LF: 260 W, HF: 65 W)
Fan cooling, 4 speeds
OFF, 100, 120Hz 24dB/oct HPF
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Clip limiting, Integral Power Protection, DC-fault
Thermal, Output over current
Thermal, Output over voltage, Output over current
INPUT1: Combo x1
INPUT2: Combo x 1 + RCA-pin x 2 (Unbalanced)
XLR3-32 x 1 (CH1 Parallel Through or CH1+CH2 Mix)
INPUT1 (XLR, TRS Phone) : 3kΩ
INPUT2 (XLR, TRS Phone, RCA Pin) : 10kΩ
INPUT1 : LINE: 0 dBu, MIC: -32 dBu
INPUT2 : 0 dBu
INPUT1 : LINE: +10 dBu, MIC: -22 dBu
INPUT2: +10 dBu
INPUT1 : LINE: +24 dBu, MIC: -8 dBu
INPUT2 : +24 dBu
LEVEL x2, LINE/MIC, HPF, D-CONTOUR, THRU/MIX, POWER
18W
60W
100 V, 100-120V, 220-240 V, 110/127/220V (Brazil), 50/60Hz
56Hz – 20kHz
2.3kHz
131dB SPL
10" cone
2"
50°
305 × 502 × 310 mm
(12.0" x 19.7" x 12.2")
14.6kg (32.2lbs)
UB-DXR10
2-way, Bi-amp powered speaker, Bass-reflex type
52Hz – 20kHz
H90° × V60° constant directivity horn
FIR-X tuning™ (Linear phase FIR filter)
2.1kHz
132dB SPL
12" cone
2.5"
Ferrite
1.4"
1" throat compression driver
Ferrite
ABS, Matte black
50° Symmetrical
362 × 601 × 350 mm
(14.2" x 23.6" x 13.7")
19.3kg (42.5lbs)
Side x 2
35mm with 2-way feature (0 or 7 degrees)
Top × 2, Rear × 1
(Fits for M10 × 18mm eyebolts)
UB-DXR12
Class-D
1100W (LF: 950W, HF: 150W)
700W (LF: 600W, HF: 100W)
Fan cooling, 4 speeds
OFF, 100, 120Hz 24dB/oct HPF
D-CONTOUR: FOH/MAIN, MONITOR, OFF
Clip limiting, Integral Power Protection, DC-fault
Thermal, Output over current
Thermal, Output over voltage, Output over current
INPUT1: XLR3-31 × 1, INPUT2: Phone × 2,
INPUT3: RCA PIN × 2
THRU: XLR3-32 × 1 (Parallel with INPUT1),
LINK OUT: XLR3-32 × 1
INPUT1: LINE: 12kΩ, MIC: 8kΩ
INPUT2,3: L, R: 40kΩ, MONO: 20kΩ
INPUT1: LINE: +1 dBu, MIC: -32 dBu
IPNUT2, 3: -13 dBu
INPUT1: LINE: +11dBu, MIC: -22dBu
INPUT2, 3: -3 dBu
INPUT1: LINE: +24 dBu, MIC: +20dBu
INPUT2, 3: +16 dBu
LEVEL × 3, LINE/MIC, HPF, D-CONTOUR, FRONT
LED DISABLE, LINK MODE, POWER
35W
110W
100V – 240V, 50Hz/60Hz
49Hz – 20kHz
2.1kHz
133dB SPL
15" cone
2.5"
50° Symmetrical
445 × 700 × 380 mm
(17.5" x 27.5" x 15.0")
22.5kg (49.6lbs)
UB-DXR15
52Hz – 20kHz
2.1kHz
131dB SPL
12" cone
2"
1.4"
50° Symmetrical
376 x 601 x 348 mm
(14.8" x 23.7" x 13.7")
15.8 kg (34.8 lbs)
Side x 2
Bottom x 2, Rear x 1
(Fit for M8 x 15 mm eyebolts)
1000 W (LF: 800 W, HF: 200 W)
465 W (LF: 400 W, HF: 65 W)
74W
50Hz – 20kHz
2.1kHz
132dB SPL
15" cone
2.5"
50° Symmetrical
455 x 700 x 378 mm
(17.9" x 27.6" x 14.9")
19.3 kg (42.6 lbs)
Specifications
0dBu is referenced to 0.775Vrms.
*1 Power rating (120V, 25°C). This is total value of individual output power.
DSR11 2
DXS12 DXS15
Powered subwoofer, Band-pass type
47Hz – 160Hz
–
–
–
131dB SPL
12" cone
2.5"
Ferrite
–
–
–
Wood, Paint, Black
–
397 × 563 × 594 mm
(15.6" x 22.2" x 23.4")
33.0kg (72.8lbs)
Side x 2
35mm (Top x 1)
–
–
Class-D
950W
600W
Fan cooling, 4 speeds
80, 100, 120Hz 24dB/oct LPF
D-XSUB: BOOST, XTENDED-LF, OFF
Clip limiting, Integral Power Protection, DC-fault
Thermal, Output over current
Thermal, Output over voltage, Output over current
INPUT: XLR3-31 × 2
THRU: XLR3-32 × 2 (Parallel with INPUT)
INPUT1: 10kΩ
–
INPUT1: +1 dBu
–
INPUT1: +11 dBu
–
INPUT1: +24 dBu
–
LEVEL, POLARITY, LPF, D-XSUB,
FRONT LED DISABLE, POWER
35W
120W
100V – 240V, 50Hz/60Hz
45Hz – 160Hz
132dB SPL
15" cone
2.5"
478 × 618 × 624 mm
(18.8" x 24.3" x 24.5")
38.0kg (83.8lbs)