Owner's Manual

ManualsBrandsYamaha ManualsDigital Mixing EnginesYamaha DME64N/24N V1

Panel Operation and Displays

Utility Displays

DME64N/24N Owner’s Manual

The following parameters are available when the DAW

parameter is set to OFF.

3 CH

Speciﬁes the device’s MIDI transmit and receive channel:

1 ~ 16.

Edit using the “List Parameters” editing procedure

described on page 41.

4 Program Change

Turns transmission and reception, the omni mode, and

echo ON or OFF for MIDI program change messages.

Move the cursor to the required parameter, then press the

[ENTER] button to alternately turn ON and OFF.

5 Control Change

Turns transmission and reception, the omni mode, and

echo ON or OFF for MIDI control change messages.

Move the cursor to the required parameter, then press the

[ENTER] button to alternately turn ON and OFF.

6 Parameter Change

Turns transmission and reception, and echo ON or OFF

for MIDI parameter change messages.

Move the cursor to the required parameter, then press the

[ENTER] button to alternately turn ON and OFF.

GPI Setup (GPI) Page

Input calibration parameters for the [GPI] connector.

1 Reset

Resets GPI calibration.

To reset the calibration, use the [E] [ ▲ ] [ ▼ ] [F]

buttons to select ALL to reset all inputs, or select an

individual input from 1 to 16 to be reset, then press the

[ENTER] button.

2 MAX

Sets the maximum calibration value.

To set the MAX value, use the [E] [ ▲ ] [ ▼ ] [F]

buttons to select ALL to set all inputs, or select an

individual input from 1 to 16 to be set, then press the

[ENTER] button to set the MAX value to the current

input voltage.

3 MIN

Sets the minimum calibration value.

To set the MIN value, use the [E] [ ▲ ] [ ▼ ] [F]

buttons to select ALL to set all inputs, or select an

individual input from 1 to 16 to be set, then press the

[ENTER] button to set the MIN value to the current

input voltage.

4 Calibration Info

Shows the calibration settings as well as the current input

voltage.

NOTE

“DAW” stands for “Digital Audio Workstation.” ProTools, Logic,

and Cubase are DAW applications, and this parameter provides

direct compatibility with a number of physical controls surfaces

that are available for use with these DAW software packages.

NOTE