Owner's Manual

Panel Operation and Displays
Utility Displays
DME64N/24N Owner’s Manual
48
Utility Display Operation
The general procedure for operating the Utility displays is
outlined below.
1. Press the [UTILITY] button for longer than
2 seconds from the Main display to go to the
Utility display.
2. Press the [UTILITY] button as many times as
necessary until the desired parameter page
appears.
3. Use the cursor buttons – [E] [ ▲ ] [ ▼ ] [F] –
to select the parameter you want to edit.
4. Press the [ENTER] button.
This either confirms a selection or edit, or calls the
appropriate parameter edit page.
Info Page
1 Name (User ID)
Shows the user ID. The user ID can be changed via the
DME Designer application running on a computer
connected to the unit.
2 Program Version
This is the current firmware version number.
3 Date
Shows the currently set date and time. The internal clock
and calendar can be set here.
Edit using the “Numeric Parameters” editing procedure
described on page 40.
4 Battery
Shows the status of the internal battery. “Low Battery” will
appear when the battery needs to be replaced, and “No
Battery” will appear when no battery is present in the
device.
Network Settings (Net) Page
Shows the Ethernet network address and other parameters.
1 Zone
Indicates whether or not the device is functioning as the
zone master: “Master” or “Slave.”
Master: the device is the zone master.
Slave: the device is a zone slave.
Edit using the “List Parameters” editing procedure
described on page 41.
NOTE
On the ICP1 the function buttons are used in place of the cursor
buttons as follows:
[F1] button: Left
[F2] button: Up
[F3] button: Right
[F5] button: Down
NOTE
The date and time (3) and the internal battery status (4 ) are
not shown on the ICP1 control panel display.
NOTE
The user ID can not be changed from the DME64N/24N
controls.
1
2
3
4
NOTE
“Zone slave” cannot be used to set this parameter.
Date/Time Parameter Edit Dialog
NOTE
Zone status of ICP1 is fixed to “Slave.” This cannot be changed.
NOTE
Make sure that one zone master is assigned for each zone.
If no zone master is assigned, no scene information will appear on
the display and scene-related control will not be possible. Mute
operations will also not be possible.
Year • Month • Day
Hour : Minute : Second
1
2
3
4