Manualshelf

Owner's Manual

ManualsBrandsYamaha ManualsDigital Mixing EnginesYamaha DME64N/24N V1
31323334353637383940
Preparation
Connection
DME64N/24N Owner’s Manual
34
REMOTE Connection
The [REMOTE] connector can be connected to remotely-controllable Yamaha AD8HR or AD824 head
amplifiers (preamplifiers), or RS-232C compatible controllers. Up to 8 head AD8HR/AD824 head amplifiers
can be connected. Control can be handled either from the Utility display HA page (described on page 54 of
this manual), or from the DME Designer application.
When connecting to a combination of AD8HR and AD824 head amplifiers, be sure to place the AD8HR
units closest to the DME64N/24N in the chain, otherwise the AD8HR unit(s) may not be properly
recognized by the DME64N/24N.
When connecting an RS-232C compatible controller set the Utility display “Misc” page “Remote” parameter
to “COM (RS232C)” – see page 51 of this manual.
NOTE
Only control signals are transmitted and received via the REMOTE connection. Audio connections must be made separately.
AD8HR
AD824 AD824 AD824
DME64N/24N
AD8HR
REMOTE
HA REMOTE 1 HA REMOTE 1
COM PC/RS422 COM RS422 COM PC/RS422 COM RS422 COM PC/RS422
HA REMOTE 2 HA REMOTE 2
9-pin D-SUB Cable (Interlink Cross)