User Manual

DM3/DM3 Standard Firmware Update Guide 8
When the Dante module could not be booted in the failsafe mode, it is shown as a fixed Device
Name like “Y001-Yamaha-DM3-xxxxxx ” with red text in the network grid view of Dante
Controller. In this case, follow the procedure “Recovery of the Dante module (without the failsafe
mode)” (page 8) to recover the system.
■ Recovery of the Dante module (without the failsafe mode)
Described below are the procedures to recover the Dante module which could not be booted in
the failsafe mode.
Preparing for the recovery
To recover the Dante module, you need to import the “FWUpdate_DM3_v******_sw***.dnt” file
into Dante Updater. The latest version can be downloaded from the Yamaha Pro Audio website.
http://www.yamahaproaudio.com/downloads/
Recovery procedure
1. Turn off the power to the DM3.
2. Separate the DM3 from the Dante network.
3. Connect the Dante [PRIMARY] connector of the DM3 to the Ethernet connector on the
computer using an Ethernet cable.
In some cases, an error may occur during recovery if you are going through a network switch.
Connect the computer with the DM3 in a one-to-one connection.
4. Turn on the power to the DM3.