User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MIDI (Setup) screen
Screen for setting MIDI IN/OUT.
Make settings for each send (Tx) and receive (Rx).
a b c d
a
Port selection buttons
For selecting the send/receive ports for MIDI.
(
USB :
USB connector
(
OFF :
Not in use
NOTE
The MIDI ports configured here are displayed as follows on your computer.
(
Scene, fader and channel ON/OFF control ports
Windows : Yamaha DM3-1
Mac : Yamaha DM3 Port1
(
DAW REMOTE port
Windows : Yamaha DM3-2
Mac : Yamaha DM3 Port2
b
Ch selection button
Selects the MIDI communication channel.
Select from Ch 1-16.
93
Screen functions and names > SETUP screen