User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
a
Auto CH Select section
(
INPUT/OUTPUT :
Sets whether to turn a channel on or not when its [ON] is turned on.
You can turn this feature ON and OFF independently for input channels and output channels.
(
[CUE] > [SEL] Link :
Sets whether to turn a channel on or not when its CUE is turned on.
(
[SEND SEL] > [CUE] Link :
Sets whether or not to link CUE with channel selection in the SENDS ON FADER mode.
(
Memorize[SEL] Position for Each FADER BANK :
Sets whether channel positions are remembered for each fader bank.
86
Screen functions and names > SETUP screen