User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Analog OUT Standards
OMNI OUT 1-8
Output impedance 75 Ω
Load impedance 10 kΩ Lines
Output level
Specified level +4 dBu (1.23 V)
Max non-clip level +24 dBu (12.3 V)
Connectors XLR-3-32 *1 (Balanced)
*1. The XLR-3-32 connector is a balanced type (1=GND, 2=HOT, 3=COLD).
PHONES
Output impedance 10 Ω
Load impedance 40 Ω Phones
Output level
Specified level 2.5 mW
Max non-clip level 100 mW
Connectors
Stereo Phone Jack (TRS) *1
(Unbalanced)
*1. Stereo Phone Jack (TRS) connector is an unbalanced type (Tip=LEFT, Ring=RIGHT, Sleeve=GND).
350
Appendix > Materials