User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Analog IN Standards
INPUT 1-16
Input impedance 10 kΩ
Source impedance 50-600 Ω Mics & 600 Ω Lines
Input level
(GAIN : +64 dB)
Sensitivity*1 -80 dBu (78 μV)
Specified level -60 dBu (0.775 mV)
Max non-clip level -40 dBu (7.75 mV)
Input level
(GAIN : 0 dB)
Sensitivity*1 -16 dBu (123 mV)
Specified level +4 dBu (1.23 V)
Max non-clip level +24 dBu (1.23 V)
Connectors
CH 1-12: XLR-3-31 *3 (Balanced)
CH 13-16: Combo Jack *3, *4 (Balanced)
*1 Sensitivity is the input level required to output +4 dBu (1.23 V) or the specified level, when all faders and
level controls are set to maximum.
*2. The XLR-3-31 connector is a balanced type (1=GND, 2=HOT, 3=COLD).
*3. The TRS phone connector is a balanced type (Tip=HOT, Ring=COLD, Sleeve=GND).
349
Appendix > Materials