User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Menu bar
File menu
The File menu allows you to work with files.
DM3 Editor supports the following file types.
File extension Description
.DM3P Used to store data for one Preset in a single file.
.DM3S Used to store data for one Scene in a single file.
.DM3F Used to store all mixer settings.
NOTE
(
You can save .DM3F files created using DM3 Editor to a USB storage device that is connected to your computer. Later, if you
connect the USB storage device to the DM3 Series console's USB connector, you can load the data directly into the console.
Similarly, you can use the DM3 Series console to save .DM3F files to a USB storage device, and then connect the device to your
computer and load the data into DM3 Editor.
(
You can drag and drop .DM3P files within the DM3 Editor screen to save and load them.
Each item in the menu is displayed below.
(
Load :
Allows you to select a saved .DM3F file and load it.
300
DM3 Editor > Menu bar