User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Setting the send levels from output channels (MIX, STEREO)
to MATRIX
This explains how to set send levels from MIX/STEREO channels to the MATRIX BUS.
1 Open the SEND FROM screen for MATRIX channels.
2 Touch the ON button for the MIX and/or STEREO channels to turn them ON (default
setting is ON).
3 Use the Pre button to switch whether to send before or after the fader.
4 Drag the SEND LEVEL sliders to adjust send levels from the MIX and/or STEREO
channels.
5 If the MATRIX BUS is set to stereo, adjust the pan with SEND PAN sliders.
NOTE
(
Left and right channel send levels can be adjusted independently for channels set to stereo, such as MIX and STEREO
channels.
(
If the MATRIX BUS is set to stereo, the SEND PAN sliders on channels set to stereo, such as MIX and STEREO channels,
become BAL (balance) sliders.
(
The MATRIX BUS can be switched between stereo and mono via the BUS SETUP screen on the SETUP screen.
Related links
“SEND FROM screen”(p.219)
289
Operating Screens > Channel-specific screens