User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Configuring the HPF
This explains how to configure the HPF (high-pass filter).
When using a vocals mike, you can reduce low-frequency noise by turning the HPF ON.
1 Open the EQ screen.
2 Touch the HPF button to turn it ON.
3 Touch the HPF handle.
4 Turn the [TOUCH AND TURN] knob to adjust the HPF.
You can also adjust it by dragging the HPF parameter field in the touch screen.
You can check the setting value in the display at top-right of the screen.
Related links
“EQ screen”(p.176)
275
Operating Screens > Channel-specific screens