User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DAW REMOTE screen
For configuring a USB MIDI port
A USB MIDI port must be configured in order to use DAW REMOTE.
Follow the steps below to do so.
1 Connect the [USB TO HOST] connector of your DM3 series to a PC with a USB cable.
2 Configure the ports of the control surface of the DAW.
Select either HUI or Mackie HUI for the type of control surface or for the remote device.
For the MIDI IN/OUT port, select Port2 for DAW REMOTE, as below.
Windows : Yamaha DM3-2
Mac : Yamaha DM3 Port2
NOTE
Port1 of the MIDI IN/OUT ports is for controlling scenes, faders, and turning channels ON/OFF.
Related links
(
“DAW REMOTE screen”(p.165)
(
“MIDI (Setup) screen”(p.93)
269
Operating Screens > DAW REMOTE screen