User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
3 Touch the oscillator output button to turn ON the oscillator output.
4 While referring to the oscillator output level meter, drag the oscillator level slider
to adjust the oscillator output level.
NOTE
(
When the oscillator mode is set to SINE WAVE, you can also adjust the frequency of the oscillator.
(
When the oscillator mode is set to BURST NOISE, you can also adjust length ON (Width) and length OFF (Interval).
Related links
“MONITOR (OSCILLATOR) screen”(p.74)
253
Operating Screens > MONITOR screen