User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Initialize Current Memory screen
The Initialize Current Memory screen allows to you reset the console's current memory to the factory default
settings. Scene memory and libraries are not reset.
a
a
INITIALIZE button
Initializes the current memory.
The following data is initialized: mixing data and setup data.
Touch to display the confirmation message. Touch the OK button to execute initialization.
Do not touch any buttons until the initialization is complete.
When initialization is complete, you can continue maintenance by selecting another menu if you do not press the Exit
button.
NOTE
When initializing the current memory, all data in the current memory is lost. Use caution when performing this operation.
231
MAINTENANCE screen > Initialize Current Memory screen