User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MAINTENANCE screen
MAINTENANCE screen
This screen is for performing maintenance on the DM3 series. To open the MAINTENANCE screen, turn the
power ON while pressing the [HOME] key.
a b c d e f
g
a
Displays the Initialize All Memory screen. （p.230)
b
Displays the Initialize Current Memory screen. （p.231)
c
Displays the Initialize Dante screen. （p.232)
d
Displays the Input Port Trim screen. (p.233)
e
Displays the Output Port Trim screen. (p.234)
f
Displays the Fader Calibration screen. （p.235)
g
Closes the MAINTENANCE screen.
229
MAINTENANCE screen > MAINTENANCE screen