User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
SEND FROM screen
The SEND FROM screen allows you to configure sends from each channel.
a
dc
b
a
ON buttons
Toggles sends from each channel ON/OFF.
b
SEND PAN sliders
Adjust the send pan from each channel.
Only shown for MIX 1-6 and MATRIX 1-2 when the Signal Type is STEREO.
Not displayed for FX 1-2.
c
SEND LEVEL sliders
Adjust the send level from each channel.
d
Pre buttons
Allows you to select whether the pre-fader or post-fader signal is sent from each channel.
(
ON:
Before the fader
(
OFF:
After the fader
219
Channel-specific screens > SEND FROM screen