User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
[MAIN] section
The [MAIN] section is primarily for operating the parameters of the STEREO channel. The channels assigned
on the CUSTOM FADER BANK screen can be customized.
When using the normal FADER BANK, or a CUSTOM FADER BANK with MAIN assigned to it, it operates SEND
MAIN in the SENDS ON FADER mode.
a
b
c
d
MAIN
a
[SEL] key
This key selects the STEREO channel to be operated. Each press of the [SEL] key toggles which of the L/R channels are
to be operated.
b
[CUE] key
The [CUE] key is for selecting the STEREO channel to monitor. The LED lights when CUE is ON.
c
[ON] key
Toggles the STEREO channel ON/OFF. This key lights when ON. To operate as SEND MAIN, toggle the send destination
bus ON/OFF in the SENDS ON FADER mode.
d
Fader
This adjusts the output level of the STEREO channel. To operate as SEND MAIN, adjust the send level to the send to
bus in the SENDS ON FADER mode.
20
Controls and functions > Top panel