User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
d
a
SEND ON buttons
Determines whether a signal is sent (ON) or not sent (OFF) to the MIX/MATRIX BUS.
b
SEND LEVEL slider
Adjusts the amount of signal sent to the MIX/MATRIX BUS.
c
Pre buttons
Selects whether the signal sent to the MIX/MATRIX BUS is sent before or after the fader.
(
ON:
Before the fader
(
OFF:
After the fader
When set to ON, you can select before EQ or before fader with the Pre Fader Send Point on the BUS SETUP screen.
d
SEND PAN slider
Displayed when the MIX/MATRIX BUS sending destination is stereo. It adjusts the sending pan.
Related links
(
“BUS SETUP screen”(p.104)
(
“Adjusting the send to MIX/MATRIX BUS level”(p.281)
(
“Adjusting the send to FX/MIX/MATRIX BUS level with faders”(p.285)
194
Channel-specific screens > SEND TO Screen