User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DYN1 (GATE/DUCKING) screen
The DYN1 screen can be used to correct the dynamic range of each channel.
When GATE is selected, if the input signal level is lower than the threshold, the output signal is reduced by a
specified amount (Range). When DUCKING is selected, if the input signal level is lower than the threshold, the
output signal is reduced by a specified amount (Range). DYN1 is available for CH 1–16.
b c d ea
h j k l nf g omi
a
DYN1 button
Turns the DYN1 function ON/OFF.
b
Type selection button
Selects either GATE or DUCKING.
c
Key In selection button
Select the Key In signal from the following.
(
Self Pre EQ
(
Self Post EQ
(
Other Ch
(
MIX
181
Channel-specific screens > DYN1 (GATE/DUCKING) screen