User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
h
Sets the EQ of channels.
The 1-knob button switches between the 1-knob mode and the manual mode.
Settings like selecting the type of 1-knob EQ mode and switching the filter type are made on the EQ screen.
Touch the jump button to open the EQ screen. (p.176)
i
Sets the DYN2 of channels.
The 1-knob button switches between the 1-knob mode and the manual mode.
Touch to highlight and then turn the [TOUCH AND TURN] knob to adjust the parameter.
Touch the jump button to open the DYN2 screen. (p.184)
153
HOME screen > SELECTED CHANNEL section