User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
CH 1-16, ST IN, FX RTN 1-2
Following is a description of the SELECTED CHANNEL section of the CH 1-16, ST IN, FX RTN 1-2 channels.
lj k
i
hgfedb ca
m
a
Displays the FX 2 screen. (p.189)
b
Displays the FX 1 screen. (p.189)
c
Displays the SEND TO screen. (p.193)
d
Displays the status of HA.
Touch to highlight and then turn the [TOUCH AND TURN] knob to adjust the gain.
Touch when highlighted to open the INPUT screen. (p.169)
Two HA are displayed on the stereo channels.
e
Displays the input port.
Touch when highlighted to open the INPUT screen. (p.169)
f
Displays the DELAY screen. (p.187)
g
Displays the LIBRARY screen. (p.221)
h
Sets the RTA Offset.
Adjusts the RTA sensitivity. Touch to highlight and then adjust with the [TOUCH AND TURN] knob.
149
HOME screen > SELECTED CHANNEL section