User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
d
Gateway
Within a network, this sets the address that identifies the device (gateway) that converts data of different media or
protocols to each other.
e
PIN for MonitorMix
Sets the PIN (4-digit numeric password) to enter when connecting to the DM3 series console with the MonitorMix
application.
MonitorMix is an application performers can use to adjust monitor balance from the stage.
f
Unit Name
Sets the name displayed in the network.
NOTE
(
When DHCP is selected as the IP address acquisition method, settings b to d are not necessary. If Static IP is selected, a screen
opens for setting b to d. Enter the values for each item.
(
Set different subnets for For Mixer Control and For Device Control.
130
Screen functions and names > SETUP screen