User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Notation
(
In this DM3 Series reference manual, the switches on the panel are called “keys.” The control knobs on the
panel are all called “knobs.” Knobs may turn from a minimum to a maximum value, or turn endlessly.
(
The virtual buttons displayed on the display are called “buttons” and the knobs are called “knobs.”
Controls on the panel are written inside brackets [ ] to distinguish them from virtual buttons and knobs
displayed onscreen. (Example: [CUE] key) The section name may be written in front of the brackets for
some controls. (Example: USER DEFINED KEYS [A] key)
12
Introduction > Notation