User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DANTE AUTO SETUP screen
The DANTE AUTO SETUP screen is for automatically configuring the DM3 Sample Rate, Latency and Bit, and
auto-patching specified devices.
a b
c d
a
Auto setup devices
Displays available AUTO SETUP devices.
b
DANTE patch display
Displays candidate devices for automatic patching.
The console ID, port number and device name of patchable ports are displayed in green.
c
DANTE setup display
Displays values for the Sample Rate, Latency and Bit set to the patch destination I/O device.
118
Screen functions and names > SETUP screen