User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DM3
a
c
b
e
d
DM3 STANDARD
a
b
c
e
d
a
All INPUT
When INPUT, allows you to switch all input sources to the [INPUT] jacks.
b
All USB
When INPUT, all input sources are switched from the computer connected to the [USB TO HOST] connector.
c
All DANTE (DM3 only)
When INPUT, it switches all input sources to the input from the Dante device.
d
Clear All
Clears all patches at one time (sets it to None).
e
Default All
Returns all patches to their defaults.
Related links
(
“Patching in/output”(p.258)
(
“Default values of IN/OUT patches”(p.341)
108
Screen functions and names > SETUP screen