User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
BUS SETUP screen
The BUS SETUP screen is for changing the basic bus settings (stereo/monorail switching, Pan Link, etc.).
These settings are included when saving a scene.
cba
a
Signal type selection buttons
Select the signal processing method for every 2 buses. Selects Stereo (links the main parameters for every 2 buses,
arranged in odd/even numerical order) or Mono x2 (used as mono x 2 channels) for each bus.
b
Pre Fader Send Point/Bus Type buttons
For specifying variable send level to Vari or fixed send level to Fixed for sending to the MIX BUS/MATRIX BUS.
Selects the send point when Send Pre under Vari is turned ON.
(
Pre EQ :
Just before EQ
(
Pre Fader :
Just before the fader
Fixed cannot be selected for the MATRIX BUS.
c
Pan Link button
Turns the Pan Link ON and OFF.
This button is displayed when the Signal Type is set to Stereo. When the button is ON, the pan of the signal sent from
the channel to the 2 corresponding buses is linked to the pan sent to the STEREO BUS.
104
Screen functions and names > SETUP screen