User Manual

d
Digital gain text box
Allows you to adjust digital gain. The default setting is 0dB. You can tap the text box and then adjust it by tapping the
up and down arrows.
e
+48V button
Turns phantom power (+48V) to the head amp ON and OFF.
(
ON:
Phantom power is turned ON.
(
OFF:
Phantom power is turned OFF.
When USB is the selected input, the +48V button is not displayed.
NOTICE
(
Phantom power
When phantom power is not needed, set the +48V button to the OFF position.
Observe the following when using phantom power to prevent damage to the console or connected devices, and signal noise.
(
Turn the +48V button OFF when the device connected to the [INPUT] jack is not compatible with phantom power.
(
Do not connect or disconnect cables when the +48V button is ON.
(
Before turning the +48V button ON/OFF, set the channel's volume to the minimum level.
NOTE
When using phantom power, noise may be generated if there is a difference in impedance between the Hot and Cold of the device
connected to [INPUT] jack.
f
Gain slider
When INPUT is selected for the input, the slider adjusts the analog gain of the head amp.
The PAD (-24 dB) is switched ON/OFF when the analog gain is adjusted between +17 dB and +18 dB.
When USB is selected for the input, the slider adjusts digital gain.
g
Φ (phase) button
Allows you to change the phase of the signal.
When turned ON, the input signal's phase is inverted.
h
Gain Unlink button
Displayed for stereo channels. While you are touching the button, gain for the left and right channels can temporarily
be adjusted individually. When you release the button, the gain for both channels can be adjusted together but the
difference in gain between the two channels is maintained.
INPUT screen menu
The following items are available in the INPUT screen's context menu.
(
All Input:
Allows you to assign the INPUT jacks as the input source for all input channels.
(
All USB:
Allows you to assign the USB TO HOST port connected to a computer as the input source for all input
channels.
(
All DANTE:
Allows you to assign the Dante device as the input source for all input channels.
57
Controls and functions > Channel-specific screens