User`s guide

CHAPTER 8: Internet Direct Connection (IDC) Service
102
English
You can download and then install update firmware using
the IDC service.
Updating the Disklavier
Using the Internet
1
Perform step 1 of “Accessing the
Internet.” (→ pg. 99)
2
Tap on .
The version confirmation process between the IDC
server and the Disklavier starts.
If there is any updated firmware available, the
following confirmation dialog appears.
3
Tap on .
The download process of the firmware starts.
Tap to cancel update.
The following confirmation dialog appears when
the download process is completed.
4
Tap on the desired option ( or
).
Note: The installation process starts
automatically when you reboot the Disklavier.
Note: Since the installation process starts
when the Disklavier is rebooted, it may take
longer than usual to operate the Disklavier after
power up.
Note: You cannot cancel the installation
process once it has started.
Tap to cancel the
installation process.
Tap to reboot the
Disklavier and install
the firmware.
Tap to install the
firmware next time you
turn on the Disklavier.
AdvancedManual.book Page 102 Monday, February 1, 2010 4:48 PM