Service manual
Table Of Contents
- CONTENTS
- TO SERVICE PERSONNEL
- FRONT PANELS
- REAR PANELS
- REMOTE CONTROL PANELS
- SPECIFICATIONS
- INTERNAL VIEW
- SET MENU TABLE
- SERVICE PRECAUTIONS
- DISASSEMBLY PROCEDURES
- UPDATING FIRMWARE
- SELF-DIAGNOSTIC FUNCTION
- Starting Self-Diagnostic Function
- Starting Self-Diagnostic Function in the protection cancel mode
- Canceling Self-Diagnostic Function
- Display provided when Self-Diagnostic Function started
- Display during Self-Diagnostic Function operation
- Operation procedure of Main menu and Sub-menu
- Functions in Self-Diagnostic Function mode
- Initial settings used to start Self-Diagnostic Function
- Details of Self-Diagnostic Function menu
- 1. DSP THROUGH
- 2. RAM THROUGH
- 3. PRO LOGIC / Neo:6
- 4. MIC CHECK
- 5. VFD CHECK
- 6. MANUAL TEST
- 7. RS-232C
- 8. FACTORY PRESET
- 9. AD DATA CHECK
- 10.IF STATUS (Input function status)
- 11.DOCK CHECK
- 12.XM CHECK
- 13.DAB CHECK
- 14.HDMI AUDIO
- 15.HDMI INFORMATION
- 16.HDMI SELECT
- 17.VIDEO CONVERSION
- 18.MODEL
- 19.VERSION/CHECK SUM
- 20.DATE
- 21. DSP CHECK
- DISPLAY DATA
- IC DATA
- BLOCK DIAGRAM
- PRINTED CIRCUIT BOARDS
- PIN CONNECTION DIAGRAMS
- SCHEMATIC DIAGRAMS
- REPLACEMENT PARTS LIST
- REMOTE CONTROL
- Adjusting the system parameters
YSP-500/HTY-750
34
YSP-500/HTY-750
4. MIC CHECK
The signal inputted through the microphone is output
via AD-DA at the output terminal of the subwoofer.
4. MIC CHECK
PRO LOGIC II PRO LOGIC II
Neo:6 Neo:6
3. PRO LOGIC / Neo:6
PRO LOGIC I, II, Neo:6 can be selected from the sub-
menu items.
PRO LOGIC I (PRO LOGIC EMULATION)
3. PRO LOGIC / Neo:6
PRO LOGIC I（PRO LOGIC EMULATION）
3.PRO LOGIC I
3.PRO LOGIC II
3. Neo:6
4.MIC CHK
5. VFD CHECK
5. VFD CHECK
Use this program to check the FL display section and
video control section. When checking the video control
section, prepare a monitor and video pin cable and
connect them.
Selection of the FL display section or video control
section varies according to the submenu operation on
the next page.
5. VFD CHECK